Hvad er fordelene ved CNC præcisionsdele behandling?

2021/07/30


1. Multi-axis control and multi-axis linkage: 

most commonly used machining centers are three-axis linkage. By increasing the swing angle and increasing the rotation coordinates, it can form four-axis linkage, five-axis linkage, seven-axis linkage, and even more-axis linkage processing. center.


2. Parallel machine tools: 

The functions of commonly used machining centers are relatively fixed. Vertical machining centers, horizontal machining centers, or machining centers, turning centers, etc. are combined to form a machining system to increase the machining range and processing capacity of the machine tool.


3. Tool breakage alarm: 

use infrared, acoustic emission, laser and other detection methods to detect the tool. If tools are found to be worn or damaged, promptly alarm, automatically compensate or replace spare tools to ensure product quality.


4. Tool life management: 

unified management of multiple blades on a tool, or several tools working at the same time, to improve processing efficiency.


5. Automatic overload protection of the machine tool:

The machine tool can automatically protect the machine tool according to the load during processing. When the load exceeds the maximum load set by the machine tool, the machine tool will automatically shut down. The load size can be set and changed by yourself.


6. Machining dynamic entity simulation: 

During the machining process, the machining state of certain parts of the machine tool is not easy to observe. If the dynamic entity simulation function is added, the machining state of the workpiece can be observed at any time, so as to prevent bad phenomena in the machining, such as Knife, over-cutting, not only, unreasonable steps, etc.


7. On-line inspection of workpieces: 

also called real-time inspection, which means real-time inspection of workpieces during processing, so that errors can be discovered and corrected in time. This function can effectively avoid the problem of re-clamping and positioning caused by unqualified inspection after conventional processing, shortening production time and improving production efficiency.

8. Adaptive control: 

The machine tool with this function can detect the changes in the cutting conditions (such as cutting force, temperature, etc.) that it senses during the machining process, and control the machine tool to change the cutting amount in time through the adaptive control system, so that the machine tool and the tool are always Maintain the best condition, so as to obtain higher cutting efficiency and processing quality, and extend the service life of the tool.